| |||||||||
|
HELMET (Cassis or Galea) The helmet is one of the most important pieces of Roman armor, and one of the most difficult to make. Roman helmets of our period were generally beaten out of a single sheet of iron or brass, a process that takes enormous skill. Some modern armorers are fully capable of turning out an extremely accurate Roman helmet made in the same fashion, and we encourage those with the means and patience to pursue this route if they wish (just be prepared to shell out upwards of $600 and wait for up to two years). However, we are also extremely fortunate to live in an age when a surprisingly large-scale industry has arisen to supply Roman reenactors with reasonably accurate off-the-shelf helmets at highly affordable prices ($200-325). Made in India, these helmets use some manufacturing shortcuts (neck guards, for example, are generally welded on) and have a few minor accuracy problems, but most of these are either easily corrected or concealed.
The Roman combat experience in Dacia under Domitian (AD 81-96) and Trajan (AD
98-117) produced further
developments in helmet design. The ability of the wicked Dacian falx, a
two-handed sickle-like sword, to reach over the Roman shield wall and pierce a
helmet like a can-opener forced the Romans to come up with countermeasures in
the form of two iron bars riveted crosswise across the helmet scull
(alternatively, two thick bronze strips might be riveted to the top of a bronze
legionary or auxiliary helmet). This started as a field modification, as seen on
several Imperial Gallic helmets with the crossbars hastily riveted right over
the decorative eyebrows. An illustration by Peter Connolly, seen above right,
depicts this type of modification to an Imperial Gallic H helmet. Crossbars are
seen on some, though not all of the legionary helmets on Trajan's Column.
The crossbars quickly became a standard feature of Roman helmet design and are found on all helmets produced from ca. AD 125 through the latter third century AD. Consequently, Legio VI favors use of helmets with crossbars, either as an added "field retrofit" (as seen on Gil's Imperial Gallic G helmet at left) or as a feature of the original construction, as with the Italic G described below. As Britain was rather far from Dacia and the crossbar modification may not have been seen as quite so necessary, Legio VI accepts the use of non-reinforced helmets as well.
The following types of helmets are acceptable for use with Legio VI Victrix
Imperial Italic G
Note: For some odd reason, a few Deepeeka versions of the Italic G sold through U.S. firms arrive with the crossbars and brow guard held on by (inaccurate) screws instead of (proper) rivets. Fortunately, the screws are easily replaced with rivets, and this modification can be performed at one of our fabricums in less than 20 minutes. Imperial Gallic G
The Deepeeka Gallic G seen here is acceptable for use with Legio VI, although if a reenactor wanted to take it to the next level, there are some minor modifications can be made to improve accuracy. Imperial Gallic H This helmet is similar in design to
the
Gallic G, but features a different
style of eyebrows and a more sloping neck guard. The most complete example of
this type is from Lech, near Augsburg, Germany. Other datable helmets indicate a
trend toward these more sloping neck guards in the last half of the first
century, which continued through the second and third centuries. However, as
both styles of neck guard were clearly used side by side, it was likely a matter
of personal preference and/or armory issue of what type could be worn by a
particular Roman soldier.
As with the Gallic G, the Deepeeka version of this helmet is acceptable for Legio VI use, but there are a few inaccurate features which can be improved through modification.
Imperial Gallic I The Deepeeka Gallic I is one of the group's more
accurate helmets and usually requires little or no no modification. Windless Steelcrafts also makes a version out of steel, not brass, which is
sometimes seen on eBay for $150-200; while there is no direct evidence such a
helmet existed, it is not implausible and acceptable for use with Legio VI. Be
aware that the Windless Steelcrafts version fits an extremely large head! Imperial Italic D
The Deepeeka version of the Italic D, illustrated
above left, has a few minor authenticity problems, but is acceptable for use
with Legio VI. Imperial Italic H The Neidermormter helmet, classified by Robinson as Imperial Italic H, is one
of the best-preserved Roman Imperial helmets to have survived from antiquity and
is a beautiful piece of the armorer's craft all around. Made of bronze (an iron
version reportedly resides in a private collection),
the helmet is heavily decorated and features and enormously deep neck guard.
The cross bracing across the skull is actually embossed, rather than applied,
and there is a rather unusual dome-shaped knob where the braces meet at the
crown of the head. This helmet is typically dated to the late Antonine or
Severan eras, ca. AD 180-235, but the find context of the helmet is unknown and
the dating is based solely on its typology (i.e. it looks about 40-60
years down the evolutionary trail from the Italic G), providing enough leeway to
allow its use for Legio VI Victrix. Early versions of the Deepeeka version of the Italic H, seen at right,
reportedly had some significant problems with fit and finish. There are reports
that these have been corrected, and if true, this helmet is now acceptable for use by our legion.
Caveat Emptor Some of the Roman helmets offered by
Albion and other providers, such as the Montifortino and Coolus models, are too early for the time period we represent.
The Imperial Gallic I helmet (Aquincum type), discovered at Ravenna, is
not recommended because it is thought to have belonged to a Marine. Alas, there is also one widely
available helmet that is simply not allowed. This is the so-called Roman Trooper's
Helmet (shown below), offered by Museum Replicas, on eBay, and at internet sites
everywhere. It is often seen with a permanently mounted crest (also inaccurate). The neck guard is in the form of a lobster tail, unlike any true
Roman neck guard, the cheek guards are of the wrong shape, the florate bosses
are incorrectly
positioned, the peak is of improper form, and, to top it off, the eyebrows are
soldered on. There is simply no way to turn this into an accurate Roman
helmet. Please do not purchase it! For the same price or only a little
more, you can buy an accurate helmet that won't cause the authenticity optio to
smite you with his baton! Crests? Crests are generally not worn by our legion, except by officers such as
Centurions and Tribunes. Cross-braced helmets
seem to lack provisions for mounting a crest, and crests are not seen on Trajan's Column (although they are seen on Antonine monuments and the Column of
Marcus Aurelius, these are usually described as an artistic convention and do
not reflect reality). Equipment displays, timeline presentations or specialist film work may
present opportunities for the wearing of crests, however. If you wish to use a crest with your helmet at a Legio VI event,
please seek permission first from the Centurion or Authenticity Optio. Suppliers We strongly recommend the following suppliers for off-the-shelf Roman helmets: Imperium Ancient Armory: Arik Greenberg and Dave
Michaels, 28039 Promontory Lane, Valencia, CA 91354. Phone:
(310) 417-8229. Website:
http://www.imperiumancientarmory.com. Email:
info@imperiumancientarmory.com.
Imperium enjoys "most-favored supplier" status with Legio VI not because two
legio members run the business (well, maybe that has something to do with
it...), but because everything they sell in the way of Roman armor is Legio
VI approved as fully authentic. In addition to the newly improved Deepeeka
helmets, armor and weapons, Imperium also makes its own highly accurate body
armor (including the Newstead and Kalkriese lorica segmentata types, currently
unavailable anywhere else), weapons (including a great pilum and/or kit),
shields, and belt components. Imperium rates everything it sells according to an
"accuracy scale," which makes it much easier to pick from among the available
products. Paid Legio VI members also get price breaks on all weapons, armor
and shields! La Wren's Nest: Lawrence and Julie Brooks, 233 Route 197, Woodstock,
CT 06281, 860-928-6908, fax 860-928-6701,
lbrroks@sbcglobal.net,
http://www.lawrensnest.com. They offer Deepeeka helmets,
mail shirts, weapons, and accessories. They fill orders in a prompt and
courteous manner. Please check
with the Authenticity Officers or Centurio before buying anything. RPG / Soul of the Warrior: Rusty Myers, 1700 Misty Court, Hanahan, SC
29406-8560. 843-437-5587, fax 843-797-7266,
Info@SouloftheWarrior.com,
http://www.SouloftheWarrior.com. He carries both Deepeeka
gear and a growing line of custom products, most of which looks pretty good from
the photos on the site. Please check
with the Authenticity Officers or Centurio before buying anything. These are modern armorers who can produce custom Roman helmets to your
specifications (lead time required is one-two years): Lonely Mountain Forge:
http://members.aol.com/gijchar/forge.html HReplikate (Germany):
http://www.hr-replikate.de/. For more information on each, visit our
SUPPLIERS PAGE. |
| ||||